Katalog CVE

CVE-2026-98294

Niskie ryzyko· EPSS 6%
Opublikowano: Zaktualizowano: Przetłumaczono: NVD NIST

Prawdopodobieństwo exploitacji (EPSS)

Niskie ryzyko
0.17%

Percentyl 6 - wyżej niż 6% wszystkich znanych CVE

Streszczenie

W jądrze Linux w sterowniku Bluetooth hci_qca występuje podatność polegająca na zapisie do zamkniętego portu szeregowego. Gdy hci_dev_open_sync() zakończy się niepowodzeniem po pomyślnym qca_setup(), port jest zamykany, ale flaga power->vregs_on pozostaje ustawiona, co prowadzi do próby zapisu do zamkniętego portu podczas usuwania sterownika. Objawia się to błędem NULL pointer dereference, co może prowadzić do awarii systemu.

Ocena ryzyka

Ryzyko obejmuje możliwość wystąpienia paniki jądra (kernel panic) lub uszkodzenia pamięci, co może prowadzić do niedostępności systemu lub naruszenia integralności danych. Podatność może być wyzwolona lokalnie przez odłączenie sterownika po awarii kontrolera Bluetooth.

Rekomendacja

Zaleca się natychmiastowe zastosowanie poprawki z oficjalnego źródła jądra Linux, która dodaje sprawdzenie flagi HCI_UART_PROTO_READY przed zapisem do portu. Należy również zaktualizować system do wersji jądra zawierającej tę poprawkę.

Inne podatności w Linux kernel

Zobacz wszystkie
Oryginalny opis (angielski, źródło NVD)

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_qca: Do not write to the serial port after it is closed hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP is set (for example, for the WCN399x family). A failed hci_dev_open_sync() following a successful qca_setup() calls hdev->close() but not hdev->shutdown(), so the port is closed while power->vregs_on is left true. qca_serdev_remove() then passes its power->vregs_on test and calls qca_power_off(), which writes to the closed port unconditionally. Seen on a WCN3988 by unbinding the driver after a controller failure. The trace below is from a 7.0.0 based kernel, where qca_power_off() was still named qca_power_shutdown(): Unable to handle kernel NULL pointer dereference at virtual address 0000000000000038 Call trace: tty_set_termios+0x50/0x238 (P) ttyport_set_baudrate+0x84/0xc0 serdev_device_set_baudrate+0x24/0x40 qca_power_shutdown+0x158/0x1fc [hci_uart] qca_serdev_remove+0x54/0x68 [hci_uart] serdev_drv_remove+0x1c/0x2c device_remove+0x4c/0x80 device_release_driver_internal+0x1cc/0x224 device_driver_detach+0x18/0x24 unbind_store+0xb4/0xc0 Check HCI_UART_PROTO_READY, which hci_uart_close() clears in the same place it closes the port, before writing to it. The regulator disable is left unconditional so the controller is still powered down. The dangling serport->tty that turns this into a use-after-free is addressed in a separate patch.

Dane podatności pochodzą z NVD (NIST) · CISA KEV · EPSS