CVE-2026-64456
HighCVSS 7.7Exploitation Probability (EPSS)
Low risk5th percentile - higher than 5% of all known CVEs
Summary
In the Linux kernel's virtio hwrng driver, a buffer over-read vulnerability exists. A malicious or buggy virtio-rng backend can report an inflated used.len, causing memcpy() to read past the vi->data array into adjacent heap memory.
Risk Assessment
The vulnerability allows leaking guest kernel heap data to userspace via /dev/hwrng and contaminates the guest RNG. In confidential-compute environments, it could be used as a data leak channel.
Recommendation
Apply the Linux kernel patch that clamps used.len in copy_data() and adds array_index_nospec(). Update to a kernel version containing this fix immediately.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: hwrng: virtio: clamp device-reported used.len at copy_data() random_recv_done() stores the device-reported used.len directly into vi->data_avail. copy_data() then indexes vi->data[] using vi->data_idx (advanced by previous copy_data() calls) and issues a memcpy() without re-validating either value against the posted buffer size sizeof(vi->data) (SMP_CACHE_BYTES bytes, typically 32 or 64). A malicious or buggy virtio-rng backend can set used.len beyond sizeof(vi->data), steering the memcpy() past the end of the inline array into adjacent kmalloc-1k slab bytes. hwrng_fillfn() mixes those bytes into the guest RNG, and guest root can also observe them directly via /dev/hwrng. Concrete impact is inside the guest: - Memory-safety / hardening: any virtio-rng backend that over-reports used.len causes the driver to read past vi->data into unrelated slab contents. hwrng_fillfn() is a kernel thread that runs as soon as the device is probed; no guest userspace interaction is required to first-trigger the OOB. - Cross-boundary leak (confidential-compute threat model): a malicious hypervisor cooperating with a malicious or compromised guest root userspace can use /dev/hwrng as a leak channel for guest-kernel heap data. The host sets a large used.len, guest root reads /dev/hwrng, and the returned bytes contain guest kernel slab contents that were adjacent to vi->data. In practice, confidential-compute guests (SEV-SNP, TDX) usually disable virtio-rng entirely, so this path is narrow, but the fix is still worth carrying because the underlying memory-safety bug contaminates the guest RNG on any host. KASAN confirms the OOB on a 7.1-rc4 guest whose virtio-rng backend has been patched to report used.len = 0x10000: BUG: KASAN: slab-out-of-bounds in virtio_read+0x394/0x5d0 Read of size 64 at addr ffff88800ae0ba20 by task hwrng/52 Call Trace: __asan_memcpy+0x23/0x60 virtio_read+0x394/0x5d0 hwrng_fillfn+0xb2/0x470 kthread+0x2cc/0x3a0 Allocated by task 1: probe_common+0xa5/0x660 virtio_dev_probe+0x549/0xbc0 The buggy address belongs to the object at ffff88800ae0b800 which belongs to the cache kmalloc-1k of size 1024 The buggy address is located 0 bytes to the right of allocated 544-byte region [ffff88800ae0b800, ffff88800ae0ba20) Same class of bug as commit c04db81cd028 ("net/9p: Fix buffer overflow in USB transport layer"), which hardened usb9pfs_rx_complete() against unchecked device-reported length in the USB 9p transport. With the clamp at point of use and array_index_nospec() in place, the same harness boots cleanly: copy_data() returns zero for the bogus report, the device-supplied bytes after data_idx are discarded, and the driver issues a fresh request.