CVE-2026-98395
UnknownSummary
In the Linux kernel on PowerPC, __replay_soft_interrupts() overwrote irq_soft_mask with IRQS_DISABLED (0x1) when replaying a pending interrupt, stripping the IRQS_PMI_DISABLED (0x2) bit. This triggered a WARN_ON in arch/powerpc/kernel/irq_64.c:75, observed early in boot on a POWER10 pseries guest. The fix replaces local_irq_disable() with hard_irq_disable().
Risk Assessment
The vulnerability causes a spurious kernel warning and an inconsistent interrupt mask state during interrupt replay on PowerPC systems, potentially leading to instability or interrupt handling errors. In environments treating warnings as errors, it may halt boot or crash the system.
Recommendation
Update the Linux kernel to a version containing the fix that replaces local_irq_disable() with hard_irq_disable() in the replayed interrupt exit path on PowerPC. If updating is not possible, consider limiting exposure of PowerPC systems or monitoring logs for the mentioned warning.
Other vulnerabilities in Linux kernel
See all- CVE-2026-98431Unknown
The Linux kernel contains an ABBA deadlock between the mmap_lock and disassociation_lock in the RDMA/uverbs subsystem. A thread performing mmap/fork acquires locks in the order mmap_lock → disassociation_lock, while the thread executing uverbs_user_mmap_disassociate() acquires them in reverse order, leading to a potential deadlock. The issue was resolved by removing disassociation_lock and using the existing hw_destroy_rwsem instead.
- CVE-2026-98430Unknown
In the Linux kernel, the RDMA/efa management IRQ handler accesses both the admin completion queue and the async event queue. The driver registered the IRQ before constructing these queues and destroyed them before freeing the IRQ, so the handler's lifetime was not contained by the resources it accesses. The fix initializes the queues with interrupts masked, requests the IRQ, then switches to interrupt mode, and on removal resets the device and frees the IRQ before destroying the queues.
- CVE-2026-98429Unknown
In the Linux kernel, the RDMA/efa completion IRQ handler accesses the EQ state and DMA buffer. Its IRQ was registered before that state was initialized, while teardown released the buffer before free_irq() synchronized the handler. The fix initializes the EQ without arming it, registers the IRQ, then arms it, and reverses the resource order during teardown by freeing the IRQ before destroying the EQ.
- CVE-2026-98428Unknown
In the Linux kernel, the USB 6fire driver uses URBs embedded in different structs for PCM, MIDI and communication, which is a buggy implementation nowadays; since a URB is managed with a refcount, this may lead to a UAF when the URB is released asynchronously. The fix converts those embedded URBs to ones properly allocated via usb_alloc_urb(), changing each embedded struct urb to a pointer and updating callers; resources are released in common destructors called at both the init error path and disconnect.
- CVE-2026-98427Unknown
In the Linux kernel, the CoDel scheduler's dropping loop in codel_dequeue() could fail to advance with very small interval values, draining the entire backlog under the qdisc lock in a single call. An unprivileged user could trigger a soft lockup this way. The fix ensures the control-law step is at least 1 tick and caps the dropping loop at 256 drops per codel_dequeue() call.
- CVE-2026-98426Unknown
In the Linux kernel, the mwifiex wifi driver's mwifiex_pcie_request_irq() registers each MSI-X vector with a per-index dev_id (&card->msix_ctx[i]). On a request_irq() failure the cleanup loop "for (j = 0; j < i; j++)" frees msix_entries[j].vector but passes the failed index's &card->msix_ctx[i] as the dev_id. Since free_irq() matches on (irq, dev_id), it fails to find the action registered with &card->msix_ctx[j]: the already-requested IRQ j is not freed (leaked) and free_irq() warns about freeing a non-existent IRQ. The fix uses &card->msix_ctx[j].
- CVE-2026-98425Unknown
In the Linux kernel, ieee80211_request_ibss_scan() in mac80211 warns when the regulatory domain leaves no allowed channel to scan. This can happen because the regdomain can change while IBSS is operating, and IBSS can continue to operate briefly during the 60s grace period until it is shut down. The fix removes the warning in this case.
- CVE-2026-98424Unknown
In the Linux kernel, cfg80211_switch_netns() in cfg80211 moves all interfaces, then moves the wiphy itself by setting its network namespace and renaming it, which makes sysfs move it. The rename can fail (only on allocation failures), leaving things mixed up and hitting a warning. The fix undoes the move and lets the change fail, and if undo fails it WARNs.
- CVE-2026-98423Unknown
In the Linux kernel, mac80211_hwsim checks ->started for frames coming from wmediumd, but the radio can be stopped after the check and before frame delivery, causing mac80211 to hit WARN_ON(!local->started). The fix expands the mutex for this case and synchronizes against it when the radio is stopped, and drops an error print that complicated the error path.
- CVE-2026-98422Unknown
In the Linux kernel, mac80211 AP_VLAN interfaces get crypto_tx_tailroom_needed_cnt from the AP interface on ifup, but it is never decremented unless the AP is also brought down. Bringing the same AP_VLAN up again increments the counter again and eventually hits the WARN_ON_ONCE sanity check. The fix resets it on ifdown.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: powerpc/entry: Fix irq_soft_mask corruption on replayed interrupt exit When __replay_soft_interrupts() replays a pending interrupt (e.g. PACA_IRQ_DEC -> timer_interrupt), it calls the handler directly with a synthetic pt_regs. The DEFINE_INTERRUPT_HANDLER_ASYNC wrapper around each handler calls arch_interrupt_async_exit_prepare() on the way out, which calls arch_interrupt_exit_prepare() -> local_irq_disable() -> arch_local_irq_disable(), which does: irq_soft_mask_set(IRQS_DISABLED) /* 0x1 */ This unconditionally overwrites irq_soft_mask with IRQS_DISABLED (0x1), stripping the IRQS_PMI_DISABLED (0x2) bit. The result is that irq_soft_mask is 0x1 instead of IRQS_ALL_DISABLED (0x3) when the handler returns to __replay_soft_interrupts(). For a normally-taken interrupt this is harmless: the next interrupt always enters through arch_interrupt_enter_prepare() which unconditionally sets irq_soft_mask to IRQS_ALL_DISABLED. But during replay, next_interrupt() is called directly between replayed handlers without going back through arch_interrupt_enter_prepare(), so the stripped bit is never restored. next_interrupt() then fires a WARNING: WARNING: arch/powerpc/kernel/irq_64.c:75 WARN_ON(irq_soft_mask_return() != IRQS_ALL_DISABLED) The warning was observed early in boot on a POWER10 pseries guest during kmem_cache_init_late(), where a spinlock release triggers interrupt replay that processes a pending timer interrupt. Debugger state confirming the bug: Before timer_interrupt(®s): irq_soft_mask = 0x3 (IRQS_ALL_DISABLED) correct irq_happened = 0x41 (HARD_DIS|REPLAYING) correct After timer_interrupt(®s) returns: irq_soft_mask = 0x1 (IRQS_DISABLED) WRONG - PMI bit stripped irq_happened = 0x41 unchanged The fix is to replace local_irq_disable() with hard_irq_disable(). hard_irq_disable() is the right primitive here for two reasons: 1. On PPC64 (hw_irq.h:301) it calls irq_soft_mask_set_return(IRQS_ALL_DISABLED), setting the soft mask to 0x3 (both IRQS_DISABLED and IRQS_PMI_DISABLED), which preserves the PMI bit and fixes the WARNING. The additional work it does (__hard_irq_disable(), PACA_IRQ_HARD_DIS |=) is redundant but safe since both are already set at this point in the exit path; the trace_hardirqs_off() inside is guarded by if (!arch_irqs_disabled_flags(flags)) so it will not double-fire. 2. On PPC32 (hw_irq.h:467) hard_irq_disable() maps to arch_local_irq_disable() -> __hard_irq_disable(), which clears MSR[EE] in hardware. This is exactly correct: PPC32 has no soft-mask PACA mechanism, so the hardware disable is the right way to satisfy irqentry_exit()'s requirement. This also fixes a build error on PPC32 where irq_soft_mask_set() is only defined under CONFIG_PPC64: arch/powerpc/include/asm/entry-common.h:273: error: implicit declaration of function 'irq_soft_mask_set' Using hard_irq_disable() requires no #ifdef and is consistent with how the rest of the entry code (e.g. entry-common.h:463) handles the same PPC32/PPC64 split.
Vulnerability data from NVD (NIST) · CISA KEV · EPSS

