CVE-2026-97570
UnknownSummary
In the Linux kernel, the bnxt_en driver has an out-of-bounds write in bnxt_alloc_agg_idx. When firmware advertises fewer concurrent TPAs (e.g., 32) than the maximum, the TPA ID can exceed the size of the rx_tpa array, leading to invalid memory access and a kernel crash at boot.
Risk Assessment
Can cause a kernel panic during boot on servers with Broadcom 57608 NICs running specific firmware versions, resulting in service unavailability and requiring a reboot.
Recommendation
Update the Linux kernel to a version containing the fix that rounds up the rx_tpa array size to the next power of two and masks the TPA ID. If updating is not possible, consider temporarily disabling TPA in the bnxt_en driver.
Other vulnerabilities in Linux kernel (bnxt_en driver)
See all- CVE-2026-97569Unknown
In the Linux kernel, the bnxt_en driver has a bug that can cause the transmit queue to stop. When the driver defers completions for a burst of packets and then a large USO packet cannot fit in a small ring, the ring may become full of packets with suppressed completions, permanently stalling the queue. This affects small rings (up to 457 descriptors) and was fixed by clearing the NO_CMPL bit in bnxt_txr_db_kick().
- CVE-2026-43260High
A vulnerability related to the RSS context deletion logic in the bnxt_en driver has been fixed in the Linux kernel. The issue was that an incorrect check of the network interface state led to VNIC leaks in firmware, potentially resulting in the loss of active RSS contexts.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: bnxt_en: Bound SW TPA IDs to prevent crashes FW supports up to 1024 concurrent TPAs, so the FW TPA ID is in the range 0..1023 (see commit ec4d8e7cf024 ("bnxt_en: Add TPA ID mapping logic for 57500 chips.")). bnxt_alloc_agg_idx is intended to wrap the FW ID down to a software ID which is used to index rxr->rx_tpa, and to generate a mapping between FW IDs and the wrapped software ID. On a 57608 with firmware version 233, the firmware advertises 32 concurrent TPAs. As of the commit under fixes, bp->max_tpa on this NIC is set to 32. If the software ID from bnxt_alloc_agg_idx is above 31, this results in an invalid address being loaded on this line: tpa_info = &rxr->rx_tpa[agg_id]; because rx_tpa is allocated with only bp->max_tpa (32) entries. Writes to tpa_info later in the code are out of bounds. This bug results in a crash at boot: Oops: general protection fault, kernel NULL pointer dereference 0x8: 0000 [#1] SMP NOPTI RIP: 0010:bnxt_rx_pkt+0xc0/0x1560 RSP: 0018:ffffc900009b8c78 EFLAGS: 00010246 RAX: 0000000000000000 RBX: 0000000000000048 RCX: 0000000206682516 RDX: ffffc900009b8db4 RSI: 0000000000000000 RDI: 01ffffff038fe1c0 RBP: ffffc9006e687480 R08: ffffc9006e687000 R09: 0000000000003048 R10: 0000000000000480 R11: ffff8881c6083900 R12: 0000000006682516 R13: ffff8881c6095400 R14: 0000000000000016 R15: ffff8881c6b66680 FS: 0000000000000000(0000) GS:ffff88fef3c77000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 00007fc8bda40584 CR3: 000000807c812001 CR4: 0000000008772ef0 PKRU: 55555554 Call Trace: <IRQ> ? __netif_receive_skb_list_core+0x1ca/0x250 __bnxt_poll_work+0x152/0x280 bnxt_poll_p5+0x1cd/0x480 __napi_poll+0x30/0x180 net_rx_action+0x20b/0x3b0 ? note_gp_changes+0x53/0xe0 ? tick_setup_sched_timer+0x180/0x180 ? __napi_schedule+0x9a/0xb0 ? bnxt_msix+0x24/0x30 handle_softirqs+0xdd/0x2c0 __irq_exit_rcu.llvm.3171231171502365008+0x47/0xf0 common_interrupt+0x85/0x90 </IRQ> <TASK> asm_common_interrupt+0x22/0x40 This stack trace is from a crash triggered when an out of bounds rx_tpa is dereferenced. The invalid write mentioned above is silent in this particular crash. Fix this by allocating rx_tpa with bp->max_tpa rounded up to the next power of 2 (bp->max_tpa_roundup_size) entries and masking the FW TPA ID with that size, so the wrapped ID can never index past the end of the array.