CVE-2026-9263
MediumCVSS 6.5Exploitation Probability (EPSS)
Low risk10th percentile - higher than 10% of all known CVEs
Summary
A vulnerability in the Zephyr Bluetooth ISO Adaptation Layer (isoal.c) allows a remote attacker to trigger an out-of-bounds read due to improper validation of the framed ISO PDU start segment length. Missing check that the segment length is at least 3 bytes causes an underflow during subtraction, copying up to 255 bytes of controller memory beyond the received PDU into an HCI ISO packet.
Risk Assessment
The organization risks disclosure of sensitive data from the Bluetooth controller memory to the host and potential denial of service (DoS) due to faults or malformed HCI ISO packets. The attack can be performed remotely by any Bluetooth CIS or BIS device the vulnerable device is synchronized with.
Recommendation
Immediately update Zephyr RTOS to a version containing the fix (v3.0.0 or later with the patch) that rejects start segments with length less than 3 bytes and adds a guard against underflow in isoal_rx_framed_consume().
Other vulnerabilities in Zephyr
See all- CVE-2026-10772Unknown
This CVE has been rejected as a duplicate. The described vulnerability involved incorrect permission checking in the Bluetooth GATT notify/indicate paths in the Zephyr stack, but was already reported as CVE-2026-2411.
- CVE-2026-10676Unknown
CVE-2026-10676 has been withdrawn as analysis determined that the reported defect is not reachable in any released version of Zephyr. In every supported release, the affected value is corrected before use.
- CVE-2026-5067Critical
Zephyr OS has a memory corruption vulnerability in the HTTP server WebSocket upgrade path. An unauthenticated remote attacker can trigger it by sending a crafted Sec-WebSocket-Key header. The bounded copy does not guarantee NUL termination, leading to out-of-bounds read/write on stack.
- CVE-2026-13735Low
Zephyr's WireGuard implementation mishandled keepalive packets. A type-4 message with a 16-byte payload (empty plaintext plus Poly1305 tag) was accepted without tag verification because wg_process_data_message() returned early before calling wg_decrypt_packet(). An attacker could send a forged keepalive without knowing the session key.
- CVE-2026-13734Medium
Vulnerability in Zephyr's WireGuard VPN: wg_process_data_message() validated the anti-replay counter too late, after committing peer-state changes (address update, timers, key rotation). An attacker can re-inject a captured packet, leading to endpoint hijacking and session disruption.
- CVE-2026-13212High
The Zephyr virtio driver does not validate the descriptor-chain head id written by the virtio device into the used ring. A malicious virtio backend can supply an out-of-range id, causing an out-of-bounds read and invocation of an attacker-controlled function pointer in the guest's interrupt context. This enables control-flow hijacking or a reliable crash.
- CVE-2026-12634Medium
A vulnerability in the NVS backend of the Zephyr settings subsystem (settings_nvs.c) causes an out-of-bounds stack write. The nvs_read() function returns the full entry length, which can exceed the buffer size, and the code uses this value as an index for writing a NUL character, leading to a write past the buffer (CWE-787).
- CVE-2026-12632Medium
A vulnerability in Zephyr RTOS's PTP receive handler allows a remote attacker to trigger an out-of-bounds read by sending a crafted PTP packet with an invalid message type (0xE or 0xF). The lack of an upper-bound check on the msg_size[] array index leads to reading beyond the array and subsequent memory operations, potentially causing a crash or limited memory corruption.
- CVE-2026-12630Medium
Zephyr's 6LoWPAN IPHC uncompression code contains an out-of-bounds read in get_ihpc_inlined_size() (subsys/net/ip/6lo.c). The destination inline size is looked up in da_inline_size_table (13 entries) using an index built from the M, DAC and DAM bits of the IPHC dispatch word; reserved combinations 13, 14 and 15 are not bounds-checked and read past the end of the table.
- CVE-2026-12366High
A use-after-free vulnerability exists in Zephyr's dynamic kernel-object disposal path. The unref_check() function frees object storage when the reference count reaches zero, but for timers (K_OBJ_TIMER) it does not cancel the active timeout, leaving a dangling node in the global timeout queue. When the timer expires, the kernel invokes the expiration handler on freed memory, causing a write to freed heap.
Original NVD description (English source)
The Zephyr Bluetooth controller ISO Adaptation Layer (subsys/bluetooth/controller/ll_sw/isoal.c) fails to validate the length field of a framed ISO PDU start segment. Per the Bluetooth specification a start segment (sc=0) always carries a 3-byte time_offset, so its segment-header len must be at least PDU_ISO_SEG_TIMEOFFSET_SIZE (3). isoal_check_seg_header() accepted start segments with len < 3 as valid, and isoal_rx_framed_consume() then computed length = seg_hdr->len - 3 in a uint8_t, underflowing to 253-255 when len is 0-2. That oversized length is passed to isoal_rx_append_to_sdu(), whose copy is clamped only against the destination SDU buffer size, not the source PDU length, so up to ~255 bytes of controller memory beyond the received PDU are copied (via sink_sdu_write_hci()/net_buf_add_mem) into an HCI ISO data packet and delivered to the host. The PDU and its segment headers are entirely attacker-controlled and arrive over the air, reachable through both the CIS and BIS-sync HCI data paths (hci_driver.c) and the vendor data path (ull_iso.c), so a remote CIS peer or a broadcaster the device is synced to can trigger an out-of-bounds read causing information disclosure to the host and potential denial of service (faults or malformed oversized HCI ISO packets). The flaw affects all Zephyr releases since framed ISO reception was introduced in v3.0.0. The fix rejects sc=0 segments with len < 3 in isoal_check_seg_header() and adds a guard before the subtraction in isoal_rx_framed_consume().