CVE-2026-74674
HighCVSS 7.8Exploitation Probability (EPSS)
Low risk2th percentile - higher than 2% of all known CVEs
Summary
A vulnerability in the Linux kernel's zap_pte_range function during direct page table reclaim causes an incorrect flush address passed to pte_free_tlb. This leads to improper TLB (paging-structure-cache) flushing, potentially resulting in use-after-free or system crashes. The issue primarily affects architectures where flushing depends on the address, such as AMD with EFER.TCE or Intel with INVPCID.
Risk Assessment
The vulnerability may cause memory mismanagement, leading to process segfaults and, in extreme cases, privilege escalation or system instability. Organizations running Linux kernels on affected architectures (AMD, Intel with INVPCID) are at risk of outages and potential data integrity breaches.
Recommendation
Apply the official patch from the Linux kernel vendor that fixes the flush address in zap_pte_range immediately. Also monitor security advisories and update systems to a patched kernel version.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: mm: fix incorrect flush address in direct page table reclaim When zap_pte_range reclaims a page table, it does: pte_free_tlb(tlb, pmd_pgtable(pmdval), addr); and this is unconditionally wrong: if this code executes, addr *always* points one past the end of the range covered by the table. The addr parameter is used to flush the TLB (really the paging-structure-cache) to drop references to the to-be-freed table, and any architecture that cares about the parameter will flush the wrong address. (But they'll still free the correct page). I think it's worth contemplating why the kernel works at all. If we hit the offending line of code, we will first clear the PMD entry (line 1954, zap_empty_pte_table), then we will issue pending flushes if force_flush is set (tlb_flush_mmu_tlbonly(tlb)), then we will skip the retry on line 1979 (phew!), and then we will do the offending pte_free_tlb call. *Or* we will clear the PMD entry immediately before pte_free_tlb (line 1983, zap_pte_table_if_empty). If we have any pending flushes (i.e. we actually zapped any last-level entries) at the time we clear the PMD entry, then the flush really ought to flush all references to the table (Linus certainly seems to think it will on all architectures [0]). The condition under which we have no accumulated flushes at the time of the clear is very complex (the whole zap_pte_range function has absurdly complex control flow). If we do hit the bad case, then we will end up clearing the PMD entry after the last time the range is flushed, and any CPU is free to cache a reference to the (empty) page table. If this happens due to an ordinary read or write, it would segfault, so it would be rare. But the cache could be speculatively filled as well. Then we'll flush the wrong address and then free and possibly reuse the table. On x86, even flushing the wrong address works on non-KPTI Intel systems because INVLPG flushes *all* paging-structure-caches, not just the ones for the target address. But INVPCID does not, and flush_tlb_one_user will use INVPCID if it's available. And then we're toast. AMD systems are more susceptible: we set the EFER.TCE bit, which makes even INVLPG only flush the target address. I think this might fix an issue in ripgrep reported here: https://github.com/BurntSushi/ripgrep/issues/3494 [0] https://lore.kernel.org/all/CA+55aFzBggoXtNXQeng5d_mRoDnaMBE5Y+URs+PHR67nUpMtaw@mail.gmail.com/T/#u