CVE-2026-74635
HighCVSS 7.8Exploitation Probability (EPSS)
Low risk3th percentile - higher than 3% of all known CVEs
Summary
In the Linux kernel fbdev driver, the bit_cursor() function did not validate the glyph index read from the screen buffer, which could lead to an out-of-bounds memory read. The issue was reported by Syzkaller and affects the write path to /dev/vcsa.
Risk Assessment
A local attacker with access to /dev/vcsa could cause a system crash (panic) or potentially gain unauthorized access to kernel memory, posing a serious risk to system integrity and confidentiality.
Recommendation
Apply the official Linux kernel patch that adds glyph index bounds checking in bit_cursor() immediately. Also restrict access to /dev/vcsa to trusted users only.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: fbdev: bitblit: bound-check glyph index in bit_cursor() bit_cursor() fetches the glyph under the cursor with c = scr_readw(vc_pos); src = vc_font.data + ((c & charmask) * w * height); where charmask is 0x1ff when vc_hi_font_mask is set. The screen buffer value comes directly from scr_readw() and may be larger than the current font's glyph count. Syzkaller triggers this via vcs_write(). The Call Trace shows vcs_write() in vc_screen.c writing an arbitrary 16-bit value with writev() to /dev/vcsa, which vcs_write_buf() in vc_screen.c stores via vcs_scr_writew() without checking charcount. The stored value is later read in bit_cursor() in bitblit.c. When the font is changed from a font with 512 glyphs to a font with 256 glyphs, the screen buffer can retain characters with the high bit set from the previous mode, which could also produce the same out-of-bounds access. BUG: KASAN: global-out-of-bounds in soft_cursor+0x378/0x6bc drivers/video/fbdev/core/softcursor.c:70 Read of size 16 at addr ffff800086c57970 Call Trace: soft_cursor+0x378/0x6bc drivers/video/fbdev/core/softcursor.c:70 bit_cursor+0xa90/0x1108 drivers/video/fbdev/core/bitblit.c:365 fbcon_cursor+0x344/0x498 drivers/video/fbdev/core/fbcon.c:1427 hide_cursor+0xdc/0x2d0 drivers/tty/vt/vt.c:883 update_region+0x100/0x18c drivers/tty/vt/vt.c:669 vcs_write+0x8ec/0xaf0 drivers/tty/vt/vc_screen.c:685 bit_putcs_aligned() and bit_putcs_unaligned() already clamp the glyph index to vc_font.charcount. Apply the same clamp in bit_cursor() after extracting the attribute and masking, before indexing fontdata. The fix completes the bounds checking started in commit 18c4ef4e765a ("fbdev: bitblit: bound-check glyph index in bit_putcs*"), which missed the cursor path. This change should be safe because the clamp reuses the existing contract from fbcon: charcount is maintained under console_lock in con_font_set() and fbcon_font_set(), and hi_font_mask is cleared when switching from 512 to 256 glyphs. When stale screen data with high bits remains after a font switch, or when vcs_write() stores an arbitrary value, clamping the index to 0 prevents the out-of-bounds read without changing cursor semantics — the same fallback bit_putcs uses.

