CVE-2026-74553
Low risk· EPSS 5%Exploitation Probability (EPSS)
Low risk5th percentile - higher than 5% of all known CVEs
Summary
In the Linux kernel, the hwmon nct6775-core driver for the NCT6116 chip used an incorrect number of temperature registers (six instead of three), leading to an out-of-bounds read (KASAN). The fix sets the number of registers to three and removes the unnecessary array.
Risk Assessment
During driver initialization, an out-of-bounds memory read may occur, potentially causing system crash or leaking kernel memory data.
Recommendation
Apply the kernel patch that hard-codes the number of temperature registers to three for NCT6116 and removes the unnecessary array.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: hwmon: (nct6775-core) Fix number of temperature registers for NCT6116 Unlike NCT6106, NCT6116 only has three temperature registers, and with it only three temperature source and temperature source configuration registers. The register addresses match those of NCT6106 and can be re-used. The code used a separate array to list the temperature source registers for NCT6116, but used the size of the NCT6106 register array to set the number of registers. The NCT6106 register array provides six addresses, while the temperature source register array for NCT6116 only provides three addresses. This causes a KASAN report. BUG: KASAN: global-out-of-bounds in nct6775_probe+0x936/0x46f0 [nct6775] Read of size 2 at addr ffffffffc19561a6 by task modprobe/954 ... Call Trace: dump_stack+0x7d/0xa7 print_address_description.constprop.0+0x1c/0x220 ? __kasan_kmalloc.constprop.0+0xc9/0xd0 ? __kmalloc_node_track_caller+0x194/0x5b0 ? nct6775_probe+0x936/0x46f0 [nct6775] ? nct6775_probe+0x936/0x46f0 [nct6775] ... Fix the problem by hard-coding the number of temperature and temperature configuration registers to three for NCT6116. Drop the unnecessary NCT6116_REG_TEMP_SOURCE array and re-use NCT6106_REG_TEMP_SOURCE.