CVE-2026-74441
Low risk· EPSS 7%Exploitation Probability (EPSS)
Low risk7th percentile - higher than 7% of all known CVEs
Summary
A vulnerability in the Linux kernel USB Type-C UCSI driver causes a race condition during port unregistration, potentially leading to use-after-free and kernel crashes (NULL pointer dereference). The issue involves synchronization of partner work items with workqueue destruction.
Risk Assessment
An attacker with physical or local access could trigger a denial of service (system crash) by exploiting the race during USB-C device disconnection. In extreme cases, kernel memory corruption may occur.
Recommendation
Apply the kernel patch from your Linux distributor that fixes the ordering and serialization during UCSI port unregistration. Update to a kernel version containing the fix.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: usb: typec: ucsi: Fix race condition and ordering in port unregistration A synchronization issue exists during port unregistration where pending partner work items can race against workqueue destruction, leading to use-after-free conditions: cros_ec_ucsi cros_ec_ucsi.3.auto: error -ETIMEDOUT: PPM init failed BUG: kernel NULL pointer dereference, address: 0000000000000000 RIP: 0010:__queue_work+0x83/0x4a0 Call Trace: <IRQ> __cfi_delayed_work_timer_fn+0x10/0x10 run_timer_softirq+0x3b6/0xbd0 sched_clock_cpu+0xc/0x110 irq_exit_rcu+0x18d/0x330 fred_sysvec_apic_timer_interrupt+0x5e/0x80 Fix this by ensuring strict ordering and proper serialization during teardown: 1. Move ucsi_unregister_partner() to the beginning of the teardown sequence and protect it under the connector mutex lock. 2. Ensure all pending partner tasks are explicitly flushed and finished before the workqueue is destroyed. 3. Switch from mod_delayed_work() to a cancel_delayed_work() and queue_delayed_work() sequence. This guarantees that items currently marked as pending won't be scheduled an additional time, preventing a double release of resources which leads to the following crash: Oops: general protection fault, probably for non-canonical address 0xdead000000000122: 0000 [#1] SMP NOPTI Workqueue: cros_ec_ucsi.3.auto-con2 ucsi_poll_worker RIP: 0010:ucsi_poll_worker+0x65/0x1e0 Call Trace: <TASK> process_scheduled_works+0x218/0x6d0 worker_thread+0x188/0x3f0 __cfi_worker_thread+0x10/0x10 kthread+0x226/0x2a0 To ensure these rules are applied identically across both the normal teardown and the ucsi_init() error paths, consolidate the cleanup logic into a new helper, ucsi_unregister_port().

