CVE-2026-74274
Low risk· EPSS 7%Exploitation Probability (EPSS)
Low risk7th percentile - higher than 7% of all known CVEs
Summary
In the Linux kernel CXL region subsystem, a vulnerability exists where NULL pointer holes can remain in the target array of an active region after removing endpoint decoders. This leads to NULL pointer dereference (general protection fault) and incorrect counting of attached decoders, potentially causing malfunction. The fix fills the first free target slot during auto-discovery.
Risk Assessment
The risk includes system crashes (kernel panic/Oops) during CXL region operations, potentially leading to memory unavailability or data corruption. Incorrect decoder counting may also cause improper region configuration, resulting in downtime in production environments.
Recommendation
It is recommended to urgently update the Linux kernel to a version containing the fix for CVE-2026-74274. Also monitor vendor security advisories and apply the appropriate backport.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: cxl/region: Fill first free targets[] slot during auto-discovery Any invalid endpoint decoder pointer in the target array of an active region is not allowed by cxl driver. This means cxl driver always assumes the first p->nr_targets entries of the target array in an auto-assembly region are valid. However, there are scenarios that could leave NULL endpoint decoder pointer holes in the target array. 1. When cxl_cancel_auto_attach() removes an endpoint decoder from a target array, the target slot is set to NULL. If the removed endpoint decoder is not the last element in the target array, the target array will contain a NULL hole. 2. When a auto-assembly region removes an assigned endpoint decoder, if the removed endpoint decoder is not the last element in the target array, always remains a NULL hole in the target array. When a NULL pointer hole exists in a region's target array, it introduces two potential problems: 1. Access an endpoint decoder via a NULL pointer. it always trigger calltrace like that. Oops: general protection fault, probably for non-canonical address 0xdffffc0000000008: 0000 [#1] SMP KASAN PTI RIP: 0010:cxl_calc_interleave_pos+0x26/0x810 [cxl_core] Call Trace: <TASK> cxl_region_attach+0xc50/0x2140 [cxl_core] cxl_add_to_region+0x321/0x2330 [cxl_core] discover_region+0x92/0x150 [cxl_port] device_for_each_child+0xf3/0x170 cxl_port_probe+0x150/0x200 [cxl_port] cxl_bus_probe+0x4f/0xa0 [cxl_core] really_probe+0x1c8/0x960 __driver_probe_device+0x323/0x450 driver_probe_device+0x45/0x120 __device_attach_driver+0x15d/0x280 bus_for_each_drv+0x10f/0x190 2. Not having enough valid endpoint decoders attached to an auto-assembly region. if an auto-assembly region is created with lock flag or assigned endpoint decoder with lock flag, which means assigned endpoint decoder will not be reset during detaching, they could re-attach to the auto-assembly region again. But cxl region driver relies on p->nr_targets to verify whether the required number of endpoint decoders has been attached, and NULL endpoint decoder pointers are still counted in that case. To fix above issues, adjust cxl_region_attach_auto() logic to find the first free target slot for endpoint decoder attachment, this ensures NULL holes in the target array are filled, rather than adding new endpoint decoders at the tail of the target array.