CVE-2026-72313
Low risk· EPSS 9%Exploitation Probability (EPSS)
Low risk9th percentile - higher than 9% of all known CVEs
Summary
In the Linux kernel DRM fb-helper, the fbdev output is now synchronized to the vblank of an active CRTC only. Previously, the first CRTC was chosen, causing warnings about vblank wait timeouts when the fbdev output was not on CRTC 0. The fix selects the first active CRTC and supports both atomic and non-atomic drivers.
Risk Assessment
This may cause incorrect display output or system log errors, but does not pose a direct security threat.
Recommendation
Apply the kernel patch to ensure proper vblank synchronization with active CRTCs.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: drm/fb-helper: Only consider active CRTCs for vblank sync Only synchronize fbdev output to the vblank of an active CRTC. Go over the list of CRTCs and pick the first that matches. Fixes warnings as the one shown below [ 77.201354] WARNING: drivers/gpu/drm/drm_vblank.c:1320 at drm_crtc_wait_one_vblank+0x194/0x1cc [drm], CPU#1: kworker/1:7/1867 [ 77.201354] omapdrm omapdrm.0: [drm] vblank wait timed out on crtc 0 This currently happens if the fbdev output is not on CRTC 0. Atomic and non-atomic drivers require distinct code paths. As for other fbdev operations, implement both and select the correct one at runtime. Not finding an active CRTC is not a bug. Do not wait in this case, but flush the display update as before. v4: - avoid possible deadlocks with locking context (Sashiko) v3: - drop excessive state validation (Jani) - acquire plane and CRTC mutices (Sashiko) v2: - move look-up code into separate helper - support drivers with legacy modesetting v1: - see https://lore.kernel.org/dri-devel/[email protected]/

