CVE-2026-72094
Low risk· EPSS 10%Exploitation Probability (EPSS)
Low risk10th percentile - higher than 10% of all known CVEs
Summary
In the Linux kernel, the dma-buf/dma-fence module has a potential NULL pointer dereference due to incorrect ordering of operations on weakly ordered platforms. The fix replaces the signaled-bit check with synchronization on the ops pointer.
Risk Assessment
The risk includes the possibility of system crashes or incorrect operation of synchronization mechanisms, which could lead to data integrity compromise.
Recommendation
It is recommended to apply the Linux kernel patch that changes the synchronization method in dma_fence_timeline_name() and dma_fence_driver_name().
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: dma-buf: dma-fence: Fix potential NULL pointer dereference The commit mentioned in the fixes tag below introduced a mechanism through which fence producers can fully decouple from fence consumers. This, desirable, mechanism is based on the fence's signaled-bit as the "decoupling point". A sophisticated interaction between RCU and atomic instructions attempts to ensure that fence consumers can still interact with fence producers through the dma_fence_ops (callback pointers into the producer). This is the desired behavior: to check for decoupling, the signaled-bit is first checked. If it's not yet signaled, RCU ensures that the ops pointer cannot yet be NULL. Hereby, dma_fence_signal_timestamp_locked() first sets the signaled-bit, and then sets the ops pointer to NULL. Readers first load the ops pointer, and then check through the signaled-bit whether the pointer can legally be accessed. These set and load operations could occur out of order on weakly ordered platforms. This problem can be solved very elegantly by using the ops pointer itself as the synchronization point. The pointer is either NULL, or cannot become NULL while it is being used thanks to RCU. Replace the signaled-bit check in dma_fence_timeline_name() and dma_fence_driver_name().