CVE-2026-72073
Low risk· EPSS 13%Exploitation Probability (EPSS)
Low risk13th percentile - higher than 13% of all known CVEs
Summary
In the vub300 MMC driver, a use-after-free vulnerability exists during failed host addition. The error path bypasses the kref lifetime management after arming the inactivity timer, potentially leading to use of freed memory.
Risk Assessment
The risk includes potential system crash or privilege escalation in a rare scenario where mmc_add_host() fails and takes over one second. Although unlikely, the flaw could be exploited to compromise kernel integrity.
Recommendation
Apply the official Linux kernel patch addressing CVE-2026-72073 immediately and update to a patched kernel version.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: mmc: vub300: fix use-after-free on probe failure The vub300 driver lifetime-manages its controller state using vub300->kref, with vub300_delete() freeing the mmc host when the last reference is dropped. The probe error path after the inactivity timer has been armed still bypasses that lifetime rule, however, and falls through to mmc_free_host() directly if mmc_add_host() fails. The race window is between arming the inactivity timer and reaching the probe error unwind after mmc_add_host() fails: probe thread timer/workqueue ------------ --------------- kref_init(&vub300->kref) ref = 1 kref_get(&vub300->kref) ref = 2, timer ref add_timer(inactivity_timer) fires after one second | | race window |<----------------------------------------------------> | mmc_add_host(mmc) inactivity timer fires vub300_queue_dead_work() kref_get() ref = 3 queue_work(deadwork) mmc_add_host() fails timer_delete_sync() mmc_free_host(mmc) frees vub300 deadwork runs use-after-free The inactivity timeout is one second, so this would require mmc_add_host() to both fail and take more than one second to do so. This is unlikely to happen in practice, but the error path is still wrong. timer_delete_sync() only waits for the timer callback itself. It does not flush deadwork that the callback may already have queued. As a result, queued deadwork can still hold a kref while the probe error path directly frees the backing mmc host, including the vub300 storage. Fix this by using the same lifetime mechanism as disconnect. Clear vub300->interface so that the timer callback and any queued deadwork return early and drop their references, then drop the initial probe reference and return without falling through to err_free_host.