CVE-2026-72007
Low risk· EPSS 10%Exploitation Probability (EPSS)
Low risk10th percentile - higher than 10% of all known CVEs
Summary
In the Linux kernel's pmdomain module for i.MX8MP, there is an issue with the VC8000E power up sequence. According to the errata, it is necessary to gate off the clock before powering up and enable it after, to avoid handshake hang.
Risk Assessment
Incorrect sequence can lead to system hang during VC8000E power up/down cycling, potentially affecting system availability.
Recommendation
Apply a Linux kernel update that includes the fix implementing the workaround for errata ERR050531.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: pmdomain: imx: Fix i.MX8MP VC8000E power up sequence Per errata[1]: ERR050531: VPU_NOC power down handshake may hang during VC8000E/VPUMIX power up/down cycling. Description: VC8000E reset de-assertion edge and AXI clock may have a timing issue. Workaround: Set bit2 (vc8000e_clk_en) of BLK_CLK_EN_CSR to 0 to gate off both AXI clock and VC8000E clock sent to VC8000E and AXI clock sent to VPU_NOC m_v_2 interface during VC8000E power up(VC8000E reset is de-asserted by HW) Add a bool variable is_errata_err050531 in 'struct imx8m_blk_ctrl_domain_data' to represent whether the workaround is needed. If is_errata_err050531 is true, first clear the clk before powering up gpc, then enable the clk after powering up gpc. [1] https://www.nxp.com/webapp/Download?colCode=IMX8MP_1P33A

