CVE-2026-64443
HighCVSS 8.1Exploitation Probability (EPSS)
Low risk20th percentile - higher than 20% of all known CVEs
Summary
In the rtl8723bs driver in the Linux kernel, an OOB read occurs in the IE loop in update_beacon_info() when a malicious AP sends a Beacon with a truncated last IE, causing pIE->length to be read out of bounds. Also, declared IE length may extend beyond the buffer.
Risk Assessment
Out-of-bounds read can lead to information disclosure or system crashes, and a remote attacker can exploit this by sending crafted frames.
Recommendation
Apply the Linux kernel patch that adds two guards: check that at least sizeof(*pIE) bytes remain and that declared IE data does not exceed the buffer. Also fixes loop iteration.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: staging: rtl8723bs: fix OOB read in update_beacon_info() IE loop The IE parsing loop in update_beacon_info() advances by (pIE->length + 2) each iteration but only guards on i < len. When a malicious AP sends a Beacon whose last IE has only one byte remaining in the frame (the element_id byte lands at len-1), the loop reads pIE->length from one byte past the allocated receive buffer. Additionally, even when the header bytes are in bounds, pIE->length itself can extend the data window beyond len, passing a truncated IE to the handler functions. Add two guards at the top of the loop body: 1. Break if fewer than sizeof(*pIE) bytes remain (can't read header). 2. Break if the IE's declared data extends past len. Also replace i += (pIE->length + 2) with i += sizeof(*pIE) + pIE->length for consistency with the sizeof(*pIE) guards added above.