CVE-2026-64405
Low risk· EPSS 7%Exploitation Probability (EPSS)
Low risk7th percentile - higher than 7% of all known CVEs
Summary
In the Linux kernel Bluetooth subsystem, a null pointer dereference was found in hci_abort_conn(). The issue occurs when hdev->sent_cmd is NULL while req_status is HCI_REQ_PEND, potentially causing a system crash.
Risk Assessment
An attacker could exploit this vulnerability to trigger a general protection fault in the hci_rx_work() receive path, leading to a denial of service (DoS) through system hang or reboot.
Recommendation
Immediately update the Linux kernel to a version containing the fix, which replaces the hdev->sent_cmd check with a new HCI_CONN_CREATE flag mechanism and synchronization via hci_cancel_connect_sync().
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_conn: Fix null ptr deref in hci_abort_conn() hci_abort_conn() read hci_skb_event(hdev->sent_cmd) when a connection was pending, but hdev->sent_cmd can be NULL while req_status is still HCI_REQ_PEND, leading to a NULL pointer dereference and a general protection fault from the hci_rx_work() receive path. Instead of inspecting hdev->sent_cmd, track the in-flight create connection command with a new per-connection HCI_CONN_CREATE flag and route all cancellation through hci_cancel_connect_sync(), which dispatches to a dedicated per-type cancel function. The create command is in exactly one of two states: still queued, or in flight. The cancel function holds cmd_sync_work_lock across the whole decision: the worker takes this lock to dequeue every entry, so while it is held a queued command cannot start running and an in-flight command cannot complete and let the next command become pending. This keeps the flag test and hci_cmd_sync_cancel() atomic with respect to the worker, so a queued command is simply dequeued, and an in-flight command owned by this connection is cancelled without the risk of cancelling an unrelated command that became pending in the meantime. CIS uses the same flag mechanism via HCI_CONN_CREATE_CIS but cannot be dequeued per-connection. hci_acl_create_conn_sync() and hci_le_create_conn_sync() clear HCI_CONN_CREATE after the create command completes, but the command status handler can free conn via hci_conn_del() (for example when the controller rejects the connection) while the worker is still blocked on the connection complete event. Hold a reference on conn across the create command so the flag can be cleared without a use-after-free.