CVE-2026-64347
Low risk· EPSS 7%Exploitation Probability (EPSS)
Low risk7th percentile - higher than 7% of all known CVEs
Summary
In the Linux kernel's USB gadget composite driver, there is an out-of-bounds read vulnerability in the USB_DT_OTG handler. The list_first_entry() function never returns NULL, so the if (!config) check is dead, leading to reading from an invalid address when the configuration list is empty.
Risk Assessment
An attacker could trigger a KASAN fault or system crash by sending an OTG request when the configuration list is empty (e.g., during gadget unbind).
Recommendation
Apply the Linux kernel patch that uses list_first_entry_or_null() instead of list_first_entry() to properly handle an empty list.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler The OTG branch of composite_setup() falls back to the first configuration when none is selected: if (cdev->config) config = cdev->config; else config = list_first_entry(&cdev->configs, struct usb_configuration, list); if (!config) goto done; ... memcpy(req->buf, config->descriptors[0], value); list_first_entry() never returns NULL. On an empty list it returns container_of() of the list head. So the "if (!config)" check is dead. When cdev->configs is empty, config points at the head inside struct usb_composite_dev. config->descriptors[0] reads whatever sits at that offset. The memcpy copies up to w_length bytes of it into the response buffer. cdev->configs can be empty in two cases. One is a teardown race on gadget unbind with a control transfer in flight. The other is a driver that sets is_otg before it adds a config. A reproducer that holds cdev->configs empty triggers a KASAN fault in this branch. Use list_first_entry_or_null() so the existing check does its job.