CVE-2026-64241
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk5th percentile - higher than 5% of all known CVEs
Summary
In the Linux kernel, multiple issues were found in the GPIO rockchip driver: a debounce clock reference leak, failure to disconnect the chained IRQ handler, and an IRQ domain leak. These bugs could lead to kernel panics and resource leaks.
Risk Assessment
The vulnerabilities could allow an attacker to trigger a kernel panic by sending a spurious interrupt after driver removal, and could lead to system resource exhaustion.
Recommendation
Apply the Linux kernel patch that registers a devm action to release the clock, clears the IRQ handler in remove(), and removes the IRQ domain during driver teardown.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: gpio: rockchip: teardown bugs and resource leaks Address several teardown issues and resource leaks in the driver's remove path and error handling: 1. Debounce clock reference leak: The debounce clock (bank->db_clk) is obtained using of_clk_get() which increments the clock's reference count, but clk_put() is never called. Register a devm action to cleanly release it on unbind. Note that of_clk_get(..., 1) remains necessary over devm_clk_get() because the DT binding does not define clock-names, precluding name-based lookup. 2. Unregistered chained IRQ handler: The chained IRQ handler is not disconnected in remove(). If a stray interrupt fires after the driver is removed, the kernel attempts to execute a stale handler, leading to a panic. Fix this by clearing the handler in remove(). 3. IRQ domain leak: The linear IRQ domain and its generic chips are allocated manually during probe but never removed. Remove the IRQ domain during driver teardown to free the associated generic chips and mappings. [Bartosz: don't emit an error message on devres allocation failure]