CVE-2026-53382
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk3th percentile - higher than 3% of all known CVEs
Summary
In the Linux kernel, a vulnerability in the vidtv driver causes a NULL pointer dereference in vidtv_mux_push_si due to missing NULL check on vidtv_mux_get_pid_ctx() return value, leading to a general protection fault. The root cause is insufficient error handling in vidtv_mux_pid_ctx_init() for PMT section PIDs.
Risk Assessment
An attacker can exploit this vulnerability to trigger a kernel panic by sending crafted data, resulting in a denial of service (DoS).
Recommendation
Apply the Linux kernel patch immediately, which adds error checking in vidtv_mux_pid_ctx_init() for PMT PIDs and defensive NULL checks in vidtv_mux_push_si().
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: media: vidtv: fix NULL pointer dereference in vidtv_mux_push_si syzbot reported a general protection fault in vidtv_psi_ts_psi_write_into [1]. vidtv_mux_get_pid_ctx() can return NULL, but vidtv_mux_push_si() does not check for this before dereferencing the returned pointer to access the continuity counter. This leads to a general protection fault when accessing a near-NULL address. The root cause is that vidtv_mux_pid_ctx_init() does not check the return value of vidtv_mux_create_pid_ctx_once() for PMT section PIDs. If the allocation fails, the PID context is never created, but init returns success. The subsequent vidtv_mux_push_si() call then gets NULL from vidtv_mux_get_pid_ctx() and crashes. Fix both the root cause (add error check in vidtv_mux_pid_ctx_init for PMT PIDs) and add defensive NULL checks in vidtv_mux_push_si for all vidtv_mux_get_pid_ctx() calls. [1] Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] SMP KASAN PTI KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007] Workqueue: events vidtv_mux_tick RIP: 0010:vidtv_psi_ts_psi_write_into+0x54a/0xbc0 drivers/media/test-drivers/vidtv/vidtv_psi.c:197 Call Trace: <TASK> vidtv_psi_table_header_write_into drivers/media/test-drivers/vidtv/vidtv_psi.c:799 [inline] vidtv_psi_pmt_write_into+0x3b2/0xa70 drivers/media/test-drivers/vidtv/vidtv_psi.c:1231 vidtv_mux_push_si+0x932/0xe80 drivers/media/test-drivers/vidtv/vidtv_mux.c:196 vidtv_mux_tick+0xe9b/0x1480 drivers/media/test-drivers/vidtv/vidtv_mux.c:408

