CVE-2026-53283
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk2th percentile - higher than 2% of all known CVEs
Summary
In the Linux kernel AMD IOMMU driver, a missing bounds check for the device ID (devid) in __rlookup_amd_iommu() caused an out-of-bounds read and a general protection fault (GPF) at boot when a PCI device was not described in the IVRS table.
Risk Assessment
The vulnerability can prevent system boot on Google Compute Engine VMs with specific hardware configurations, leading to a kernel-level denial of service (DoS).
Recommendation
Apply the Linux kernel patch that adds devid bounds checking in __rlookup_amd_iommu() or update to a kernel version containing this fix.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: iommu/amd: Bounds-check devid in __rlookup_amd_iommu() iommu_device_register() walks every device on the PCI bus via bus_for_each_dev() and calls amd_iommu_probe_device() for each. The inlined check_device() path computes the device's sbdf, calls rlookup_amd_iommu() to find the owning IOMMU, and only afterwards verifies devid <= pci_seg->last_bdf. __rlookup_amd_iommu() indexes rlookup_table[devid] with no bounds check of its own, so for a PCI device whose BDF is not described by the IVRS, the lookup reads past the end of the allocation before the caller's bounds check can run. This was harmless before commit e874c666b15b ("iommu/amd: Change rlookup, irq_lookup, and alias to use kvalloc()"): the table was a zeroed page-order allocation, so the over-read returned NULL and the caller's NULL check skipped the device. After that commit the table is a tight kvcalloc() and the over-read returns adjacent slab contents, which check_device() then dereferences as a struct amd_iommu *, causing a boot-time GPF. Seen on Google Compute Engine ct6e VMs, where the virtualized IVRS describes only the four TPU endpoints 00:04.0-07.0; the gVNIC at 00:08.0 (devid 0x40) indexes 56 bytes past the 456-byte allocation, into the adjacent kmalloc-512 slab object: pci 0000:00:04.0: Adding to iommu group 0 pci 0000:00:05.0: Adding to iommu group 1 pci 0000:00:06.0: Adding to iommu group 2 pci 0000:00:07.0: Adding to iommu group 3 Oops: general protection fault, probably for non-canonical address 0x3a64695f78746382: 0000 [#1] SMP NOPTI CPU: 0 UID: 0 PID: 1 Comm: swapper/0 Not tainted 6.18.22 #1 Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 12/06/2025 RIP: 0010:amd_iommu_probe_device+0x54/0x3a0 Call Trace: __iommu_probe_device+0x107/0x520 probe_iommu_group+0x29/0x50 bus_for_each_dev+0x7e/0xe0 iommu_device_register+0xc9/0x240 iommu_go_to_state+0x9c0/0x1c60 amd_iommu_init+0x14/0x40 pci_iommu_init+0x16/0x60 do_one_initcall+0x47/0x2f0 Guard the array access in __rlookup_amd_iommu(). With the fix applied on 6.18.22, the gVNIC at 00:08.0 is skipped cleanly and the VM boots.

