CVE-2026-53237
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk7th percentile - higher than 7% of all known CVEs
Summary
A NULL pointer dereference vulnerability was found in the Linux kernel's GPIO driver for Marvell Armada. The suspend/resume functions are called for all GPIO banks, but only some support PWM. Accessing the mvpwm structure in a bank without PWM causes a kernel panic.
Risk Assessment
This vulnerability can cause a system crash (kernel panic) during suspend/resume operations, leading to service disruption and potential data loss.
Recommendation
Immediately update the Linux kernel to a version that includes the fix adding a NULL check before calling PWM functions in the mvebu-gpio driver.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: gpio: mvebu: fix NULL pointer dereference in suspend/resume mvebu_pwm_suspend() and mvebu_pwm_resume() are called for all GPIO banks during suspend/resume, but not all banks have PWM functionality. GPIO banks without PWM have mvchip->mvpwm set to NULL. Calling mvebu_pwm_suspend() with mvpwm == NULL causes a NULL pointer dereference when it tries to access mvpwm->blink_select. Unable to handle kernel NULL pointer dereference at virtual address 00000020 when write [00000020] *pgd=00000000 Internal error: Oops: 815 [#1] PREEMPT ARM Modules linked in: CPU: 0 UID: 0 PID: 406 Comm: sh Not tainted 6.12.74-rt12-yocto-standard-g4e96f98fb7db-dirty #353 Hardware name: Marvell Armada 370/XP (Device Tree) PC is at regmap_mmio_read+0x38/0x54 LR is at regmap_mmio_read+0x38/0x54 pc : [<c05fd2ac>] lr : [<c05fd2ac>] psr: 200f0013 sp : f0c11d10 ip : 00000000 fp : c100d2f0 r10: c14fb854 r9 : 00000000 r8 : 00000000 r7 : c1799c00 r6 : 00000020 r5 : 00000020 r4 : c179c7c0 r3 : f0a231a0 r2 : 00000020 r1 : 00000020 r0 : 00000000 Flags: nzCv IRQs on FIQs on Mode SVC_32 ISA ARM Segment none Control: 10c5387d Table: 135ec059 DAC: 00000051 Call trace: regmap_mmio_read from _regmap_bus_reg_read+0x78/0xac _regmap_bus_reg_read from _regmap_read+0x60/0x154 _regmap_read from regmap_read+0x3c/0x60 regmap_read from mvebu_gpio_suspend+0xa4/0x14c mvebu_gpio_suspend from dpm_run_callback+0x54/0x180 dpm_run_callback from device_suspend+0x124/0x630 device_suspend from dpm_suspend+0x124/0x270 dpm_suspend from dpm_suspend_start+0x64/0x6c dpm_suspend_start from suspend_devices_and_enter+0x140/0x8e8 suspend_devices_and_enter from pm_suspend+0x2fc/0x308 pm_suspend from state_store+0x6c/0xc8 state_store from kernfs_fop_write_iter+0x10c/0x1f8 kernfs_fop_write_iter from vfs_write+0x270/0x468 vfs_write from ksys_write+0x70/0xf0 ksys_write from ret_fast_syscall+0x0/0x54 Add a NULL check for mvchip->mvpwm before calling the PWM suspend/resume functions.

