CVE-2026-53111
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk2th percentile - higher than 2% of all known CVEs
Summary
A null pointer dereference vulnerability was found in the Linux kernel's bpf_lwt_xmit_push_encap function. The issue occurs when skb->_skb_refdst is not initialized during BPF program test runs, leading to a kernel crash.
Risk Assessment
An attacker with BPF program execution privileges can intentionally trigger this vulnerability, causing a kernel panic and system denial of service.
Recommendation
Apply the patch available in the latest Linux kernel version that adds initialization of skb->_skb_refdst before calling bpf_test_run. Update your system to a stable release containing this fix.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: bpf: test_run: Fix the null pointer dereference issue in bpf_lwt_xmit_push_encap The bpf_lwt_xmit_push_encap helper needs to access skb_dst(skb)->dev to calculate the needed headroom: err = skb_cow_head(skb, len + LL_RESERVED_SPACE(skb_dst(skb)->dev)); But skb->_skb_refdst may not be initialized when the skb is set up by bpf_prog_test_run_skb function. Executing bpf_lwt_push_ip_encap function in this scenario will trigger null pointer dereference, causing a kernel crash as Yinhao reported: [ 105.186365] BUG: kernel NULL pointer dereference, address: 0000000000000000 [ 105.186382] #PF: supervisor read access in kernel mode [ 105.186388] #PF: error_code(0x0000) - not-present page [ 105.186393] PGD 121d3d067 P4D 121d3d067 PUD 106c83067 PMD 0 [ 105.186404] Oops: 0000 [#1] PREEMPT SMP NOPTI [ 105.186412] CPU: 3 PID: 3250 Comm: poc Kdump: loaded Not tainted 6.19.0-rc5 #1 [ 105.186423] Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.16.3-debian-1.16.3-2 04/01/2014 [ 105.186427] RIP: 0010:bpf_lwt_push_ip_encap+0x1eb/0x520 [ 105.186443] Code: 0f 84 de 01 00 00 0f b7 4a 04 66 85 c9 0f 85 47 01 00 00 31 c0 5b 5d 41 5c 41 5d 41 5e c3 cc cc cc cc 48 8b 73 58 48 83 e6 fe <48> 8b 36 0f b7 be ec 00 00 00 0f b7 b6 e6 00 00 00 01 fe 83 e6 f0 [ 105.186449] RSP: 0018:ffffbb0e0387bc50 EFLAGS: 00010246 [ 105.186455] RAX: 000000000000004e RBX: ffff94c74e036500 RCX: ffff94c74874da00 [ 105.186460] RDX: 0000000000000000 RSI: 0000000000000000 RDI: ffff94c74e036500 [ 105.186463] RBP: 0000000000000001 R08: 0000000000000002 R09: 0000000000000000 [ 105.186467] R10: ffffbb0e0387bd50 R11: 0000000000000000 R12: ffffbb0e0387bc98 [ 105.186471] R13: 0000000000000014 R14: 0000000000000000 R15: 0000000000000002 [ 105.186484] FS: 00007f166aa4d680(0000) GS:ffff94c8b7780000(0000) knlGS:0000000000000000 [ 105.186490] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 [ 105.186494] CR2: 0000000000000000 CR3: 000000015eade001 CR4: 0000000000770ee0 [ 105.186499] PKRU: 55555554 [ 105.186502] Call Trace: [ 105.186507] <TASK> [ 105.186513] bpf_lwt_xmit_push_encap+0x2b/0x40 [ 105.186522] bpf_prog_a75eaad51e517912+0x41/0x49 [ 105.186536] ? kvm_clock_get_cycles+0x18/0x30 [ 105.186547] ? ktime_get+0x3c/0xa0 [ 105.186554] bpf_test_run+0x195/0x320 [ 105.186563] ? bpf_test_run+0x10f/0x320 [ 105.186579] bpf_prog_test_run_skb+0x2f5/0x4f0 [ 105.186590] __sys_bpf+0x69c/0xa40 [ 105.186603] __x64_sys_bpf+0x1e/0x30 [ 105.186611] do_syscall_64+0x59/0x110 [ 105.186620] entry_SYSCALL_64_after_hwframe+0x76/0xe0 [ 105.186649] RIP: 0033:0x7f166a97455d Temporarily add the setting of skb->_skb_refdst before bpf_test_run to resolve the issue.