CVE-2026-53024
HighCVSS 7.8Exploitation Probability (EPSS)
Low risk3th percentile - higher than 3% of all known CVEs
Summary
A use-after-free vulnerability was found in the Linux kernel's Greybus RAW driver. If a user writes to the character device after disconnect has been called, a NULL pointer dereference occurs causing a kernel panic. The issue is due to missing synchronization between write operations and connection destruction.
Risk Assessment
An attacker with local system access can deliberately trigger a write after disconnect, causing a kernel panic and potential denial of service.
Recommendation
Apply the Linux kernel patch that fixes the greybus/raw driver immediately. If not possible, temporarily restrict access to greybus devices to unauthorized users.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: greybus: raw: fix use-after-free if write is called after disconnect If a user writes to the chardev after disconnect has been called, the kernel panics with the following trace (with CONFIG_INIT_ON_FREE_DEFAULT_ON=y): BUG: kernel NULL pointer dereference, address: 0000000000000218 ... Call Trace: <TASK> gb_operation_create_common+0x61/0x180 gb_operation_create_flags+0x28/0xa0 gb_operation_sync_timeout+0x6f/0x100 raw_write+0x7b/0xc7 [gb_raw] vfs_write+0xcf/0x420 ? task_mm_cid_work+0x136/0x220 ksys_write+0x63/0xe0 do_syscall_64+0xa4/0x290 entry_SYSCALL_64_after_hwframe+0x77/0x7f Disconnect calls gb_connection_destroy, which ends up freeing the connection object. When gb_operation_sync is called in the write file operations, its gets a freed connection as parameter and the kernel panics. The gb_connection_destroy cannot be moved out of the disconnect function, as the Greybus subsystem expect all connections belonging to a bundle to be destroyed when disconnect returns. To prevent this bug, use a rw lock to synchronize access between write and disconnect. This guarantees that the write function doesn't try to use a disconnected connection.

