CVE-2026-52938
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk1th percentile - higher than 1% of all known CVEs
Summary
A NULL pointer dereference vulnerability was found in the Linux kernel's BPF subsystem within bpf_sk_storage_clone and bpf_sk_storage_diag_put_all functions. A concurrent RCU reader can observe a storage element (selem) still on the list after its smap pointer has been cleared by bpf_selem_unlink_nofail(), leading to a crash.
Risk Assessment
An attacker could trigger a general protection fault, causing a denial of service (DoS). In worst-case scenarios, this might lead to privilege escalation or information disclosure.
Recommendation
Apply the latest kernel patch that adds a NULL check for smap in bpf_sk_storage_clone and passes the validated smap directly to diag_get.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: bpf: Fix NULL pointer dereference in bpf_sk_storage_clone and diag paths bpf_selem_unlink_nofail() sets SDATA(selem)->smap to NULL before removing the selem from the storage hlist. A concurrent RCU reader in bpf_sk_storage_clone() can observe the selem still on the list with smap already NULL, causing a NULL pointer dereference. general protection fault, probably for non-canonical address 0xdffffc000000000a: KASAN: null-ptr-deref in range [0x0000000000000050-0x0000000000000057] RIP: 0010:bpf_sk_storage_clone+0x1cd/0xaa0 net/core/bpf_sk_storage.c:174 Call Trace: <IRQ> sk_clone+0xfed/0x1980 net/core/sock.c:2591 inet_csk_clone_lock+0x30/0x760 net/ipv4/inet_connection_sock.c:1222 tcp_create_openreq_child+0x35/0x2680 net/ipv4/tcp_minisocks.c:571 tcp_v4_syn_recv_sock+0x123/0xf90 net/ipv4/tcp_ipv4.c:1729 tcp_check_req+0x8e1/0x2580 include/net/tcp.h:855 tcp_v4_rcv+0x1845/0x3b80 net/ipv4/tcp_ipv4.c:2347 Add a NULL check for smap in bpf_sk_storage_clone(). bpf_sk_storage_diag_put_all() has the same issue. Add a NULL check and pass the validated smap directly to diag_get(), which is refactored to take smap as a parameter instead of reading it internally. bpf_sk_storage_diag_put() uses diag->maps[i] which is always valid under its refcount, so diag->maps[i] is passed directly to diag_get().