CVE-2026-52925
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk6th percentile - higher than 6% of all known CVEs
Summary
In the Linux kernel VRF subsystem, a potential NULL pointer dereference (NPD) was found when removing a port from a VRF. RCU readers may assume a net device is a VRF port and call l3mdev operations on a new master device (e.g., a bridge) that lacks them, leading to NULL dereference.
Risk Assessment
An attacker could exploit this vulnerability to cause a kernel panic by manipulating network configuration, resulting in a denial of service (DoS) on the system.
Recommendation
Immediately update the Linux kernel to a version containing the fix that adds RCU synchronization after clearing the IFF_L3MDEV_SLAVE flag from a VRF port.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: vrf: Fix a potential NPD when removing a port from a VRF RCU readers that identified a net device as a VRF port using netif_is_l3_slave() assume that a subsequent call to netdev_master_upper_dev_get_rcu() will return a VRF device. They then continue to dereference its l3mdev operations. This assumption is not always correct and can result in a NPD [1]. There is no RCU synchronization when removing a port from a VRF, so it is possible for an RCU reader to see a new master device (e.g., a bridge) that does not have l3mdev operations. Fix by adding RCU synchronization after clearing the IFF_L3MDEV_SLAVE flag. Skip this synchronization when a net device is removed from a VRF as part of its deletion and when the VRF device itself is deleted. In the latter case an RCU grace period will pass by the time RTNL is released. [1] BUG: kernel NULL pointer dereference, address: 0000000000000000 [...] RIP: 0010:l3mdev_fib_table_rcu (net/l3mdev/l3mdev.c:181) [...] Call Trace: <TASK> l3mdev_fib_table_by_index (net/l3mdev/l3mdev.c:201 net/l3mdev/l3mdev.c:189) __inet_bind (net/ipv4/af_inet.c:499 (discriminator 3)) inet_bind_sk (net/ipv4/af_inet.c:469) __sys_bind (./include/linux/file.h:62 (discriminator 1) ./include/linux/file.h:83 (discriminator 1) net/socket.c:1951 (discriminator 1)) __x64_sys_bind (net/socket.c:1969 (discriminator 1) net/socket.c:1967 (discriminator 1) net/socket.c:1967 (discriminator 1)) do_syscall_64 (arch/x86/entry/syscall_64.c:63 (discriminator 1) arch/x86/entry/syscall_64.c:94 (discriminator 1)) entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:130)