CVE-2026-46265
HighCVSS 7.5Exploitation Probability (EPSS)
Low risk30th percentile - higher than 30% of all known CVEs
Summary
In the Linux kernel, a problem was detected in the RDMA hns driver where during a reset triggered by sunrpc, the hns_roce_irq_workq workqueue is flushed but lacks the WQ_MEM_RECLAIM flag, causing a warning and potential memory allocation issues. The issue occurs during QP destruction, leading to memory leaks.
Risk Assessment
The risk is potential memory exhaustion and system instability during RDMA operations, especially in environments using sunrpc, which could lead to crashes or performance degradation.
Recommendation
It is recommended to apply the Linux kernel patch that adds the WQ_MEM_RECLAIM flag to the hns_roce_irq_workq workqueue to prevent warnings and potential memory issues.
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: RDMA/hns: Fix WQ_MEM_RECLAIM warning When sunrpc is used, if a reset triggered, our wq may lead the following trace: workqueue: WQ_MEM_RECLAIM xprtiod:xprt_rdma_connect_worker [rpcrdma] is flushing !WQ_MEM_RECLAIM hns_roce_irq_workq:flush_work_handle [hns_roce_hw_v2] WARNING: CPU: 0 PID: 8250 at kernel/workqueue.c:2644 check_flush_dependency+0xe0/0x144 Call trace: check_flush_dependency+0xe0/0x144 start_flush_work.constprop.0+0x1d0/0x2f0 __flush_work.isra.0+0x40/0xb0 flush_work+0x14/0x30 hns_roce_v2_destroy_qp+0xac/0x1e0 [hns_roce_hw_v2] ib_destroy_qp_user+0x9c/0x2b4 rdma_destroy_qp+0x34/0xb0 rpcrdma_ep_destroy+0x28/0xcc [rpcrdma] rpcrdma_ep_put+0x74/0xb4 [rpcrdma] rpcrdma_xprt_disconnect+0x1d8/0x260 [rpcrdma] xprt_rdma_connect_worker+0xc0/0x120 [rpcrdma] process_one_work+0x1cc/0x4d0 worker_thread+0x154/0x414 kthread+0x104/0x144 ret_from_fork+0x10/0x18 Since QP destruction frees memory, this wq should have the WQ_MEM_RECLAIM.

