CVE-2026-46255
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk2th percentile - higher than 2% of all known CVEs
Summary
In the Linux kernel fsl-edma DMA driver, the fsl_edma_remove() function manually disables clocks that are already automatically managed by devm_clk_get_enabled(). This triggers warnings on driver removal about attempting to disable an already disabled clock.
Risk Assessment
Warnings may indicate power management issues and clutter system logs, but do not pose a direct security threat.
Recommendation
Apply the Linux kernel patch that removes the unnecessary fsl_disable_clocks() call in fsl_edma_remove().
Other vulnerabilities in Linux kernel
See all- CVE-2026-14367Low
A vulnerability in the I3C IBI subsystem of the Linux kernel (drivers/i3c/i3c_ibi_workq.c) stems from missing synchronization on the free-list of work nodes (sys_slist_t). Allocation and deallocation helpers are called from interrupt context (ISR) and the workqueue thread without locks, leading to a race condition. An attacker with physical access to the I3C bus can trigger a series of interrupts, causing list corruption, double allocation, or out-of-bounds writes.
- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: dmaengine: fsl-edma: don't explicitly disable clocks in .remove() The clocks in fsl_edma_engine::muxclk are allocated and enabled with devm_clk_get_enabled(), which automatically cleans these resources up, but these clocks are also manually disabled in fsl_edma_remove(). This causes warnings on driver removal for each clock: edma_module already disabled WARNING: CPU: 0 PID: 418 at drivers/clk/clk.c:1200 clk_core_disable+0x198/0x1c8 [...] Call trace: clk_core_disable+0x198/0x1c8 (P) clk_disable+0x34/0x58 fsl_edma_remove+0x74/0xe8 [fsl_edma] [...] ---[ end trace 0000000000000000 ]--- edma_module already unprepared WARNING: CPU: 0 PID: 418 at drivers/clk/clk.c:1059 clk_core_unprepare+0x1f8/0x220 [...] Call trace: clk_core_unprepare+0x1f8/0x220 (P) clk_unprepare+0x34/0x58 fsl_edma_remove+0x7c/0xe8 [fsl_edma] [...] ---[ end trace 0000000000000000 ]--- Fix these warnings by removing the unnecessary fsl_disable_clocks() call in fsl_edma_remove().

