CVE-2026-23438
MediumCVSS 5.5Exploitation Probability (EPSS)
Low risk3th percentile - higher than 3% of all known CVEs
Summary
In the Linux kernel's mvpp2 driver for Marvell PP2/CP11X, a NULL pointer dereference vulnerability exists. The mvpp2_bm_switch_buffers() function unconditionally calls flow control update without checking if the CM3 SRAM resource is available, causing a kernel panic on MTU changes.
Risk Assessment
An attacker can trigger an MTU change (e.g., via network interface) causing a kernel panic, leading to denial of service (DoS). The vulnerability affects systems missing the CM3 SRAM device tree configuration.
Recommendation
Apply the kernel patch that guards mvpp2_bm_pool_update_priv_fc() calls with priv->global_tx_fc check. Update to a patched kernel version immediately.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: net: mvpp2: guard flow control update with global_tx_fc in buffer switching mvpp2_bm_switch_buffers() unconditionally calls mvpp2_bm_pool_update_priv_fc() when switching between per-cpu and shared buffer pool modes. This function programs CM3 flow control registers via mvpp2_cm3_read()/mvpp2_cm3_write(), which dereference priv->cm3_base without any NULL check. When the CM3 SRAM resource is not present in the device tree (the third reg entry added by commit 60523583b07c ("dts: marvell: add CM3 SRAM memory to cp11x ethernet device tree")), priv->cm3_base remains NULL and priv->global_tx_fc is false. Any operation that triggers mvpp2_bm_switch_buffers(), for example an MTU change that crosses the jumbo frame threshold, will crash: Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000 Mem abort info: ESR = 0x0000000096000006 EC = 0x25: DABT (current EL), IL = 32 bits pc : readl+0x0/0x18 lr : mvpp2_cm3_read.isra.0+0x14/0x20 Call trace: readl+0x0/0x18 mvpp2_bm_pool_update_fc+0x40/0x12c mvpp2_bm_pool_update_priv_fc+0x94/0xd8 mvpp2_bm_switch_buffers.isra.0+0x80/0x1c0 mvpp2_change_mtu+0x140/0x380 __dev_set_mtu+0x1c/0x38 dev_set_mtu_ext+0x78/0x118 dev_set_mtu+0x48/0xa8 dev_ifsioc+0x21c/0x43c dev_ioctl+0x2d8/0x42c sock_ioctl+0x314/0x378 Every other flow control call site in the driver already guards hardware access with either priv->global_tx_fc or port->tx_fc. mvpp2_bm_switch_buffers() is the only place that omits this check. Add the missing priv->global_tx_fc guard to both the disable and re-enable calls in mvpp2_bm_switch_buffers(), consistent with the rest of the driver.