CVE-2026-10678
HighCVSS 8.1Exploitation Probability (EPSS)
Low risk26th percentile - higher than 26% of all known CVEs
Summary
A vulnerability in Zephyr (MCTP-over-I2C+GPIO) allows an attacker to write an arbitrary byte via an uninitialized pointer and a one-byte heap overflow. Lack of validation of write order and receive buffer enables remote memory corruption or system crash.
Risk Assessment
The organization risks device takeover or denial of service (DoS) by a malicious I2C bus master, without authentication.
Recommendation
Update Zephyr to a patched version (v4.4.1 or later). If not possible, restrict I2C bus access to trusted controllers only.
Other vulnerabilities in Zephyr
See all- CVE-2026-10772Unknown
This CVE has been rejected as a duplicate. The described vulnerability involved incorrect permission checking in the Bluetooth GATT notify/indicate paths in the Zephyr stack, but was already reported as CVE-2026-2411.
- CVE-2026-10676Unknown
CVE-2026-10676 has been withdrawn as analysis determined that the reported defect is not reachable in any released version of Zephyr. In every supported release, the affected value is corrected before use.
- CVE-2026-5067Critical
Zephyr OS has a memory corruption vulnerability in the HTTP server WebSocket upgrade path. An unauthenticated remote attacker can trigger it by sending a crafted Sec-WebSocket-Key header. The bounded copy does not guarantee NUL termination, leading to out-of-bounds read/write on stack.
- CVE-2026-13735Low
Zephyr's WireGuard implementation mishandled keepalive packets. A type-4 message with a 16-byte payload (empty plaintext plus Poly1305 tag) was accepted without tag verification because wg_process_data_message() returned early before calling wg_decrypt_packet(). An attacker could send a forged keepalive without knowing the session key.
- CVE-2026-13734Medium
Vulnerability in Zephyr's WireGuard VPN: wg_process_data_message() validated the anti-replay counter too late, after committing peer-state changes (address update, timers, key rotation). An attacker can re-inject a captured packet, leading to endpoint hijacking and session disruption.
- CVE-2026-13212High
The Zephyr virtio driver does not validate the descriptor-chain head id written by the virtio device into the used ring. A malicious virtio backend can supply an out-of-range id, causing an out-of-bounds read and invocation of an attacker-controlled function pointer in the guest's interrupt context. This enables control-flow hijacking or a reliable crash.
- CVE-2026-12634Medium
A vulnerability in the NVS backend of the Zephyr settings subsystem (settings_nvs.c) causes an out-of-bounds stack write. The nvs_read() function returns the full entry length, which can exceed the buffer size, and the code uses this value as an index for writing a NUL character, leading to a write past the buffer (CWE-787).
- CVE-2026-12632Medium
A vulnerability in Zephyr RTOS's PTP receive handler allows a remote attacker to trigger an out-of-bounds read by sending a crafted PTP packet with an invalid message type (0xE or 0xF). The lack of an upper-bound check on the msg_size[] array index leads to reading beyond the array and subsequent memory operations, potentially causing a crash or limited memory corruption.
- CVE-2026-12630Medium
Zephyr's 6LoWPAN IPHC uncompression code contains an out-of-bounds read in get_ihpc_inlined_size() (subsys/net/ip/6lo.c). The destination inline size is looked up in da_inline_size_table (13 entries) using an index built from the M, DAC and DAM bits of the IPHC dispatch word; reserved combinations 13, 14 and 15 are not bounds-checked and read past the end of the table.
- CVE-2026-12366High
A use-after-free vulnerability exists in Zephyr's dynamic kernel-object disposal path. The unref_check() function frees object storage when the reference count reaches zero, but for timers (K_OBJ_TIMER) it does not cancel the active timeout, leaving a dangling node in the global timeout queue. When the timer expires, the kernel invokes the expiration handler on freed memory, causing a write to freed heap.
Original NVD description (English source)
The MCTP-over-I2C+GPIO target binding in Zephyr (subsys/pmci/mctp/mctp_i2c_gpio_target.c) processes pseudo-register writes from an I2C bus master byte-by-byte in mctp_i2c_gpio_target_write_received() without validating the order or the receive buffer. In the affected versions the MCTP_I2C_GPIO_RX_MSG_ADDR (data) handler dereferences and writes through b->rx_pkt without checking that the receive buffer was allocated: a controller that selects the data register and writes a byte without first sending the length register (which is what allocates the buffer) causes a write of an attacker-chosen byte through a NULL/unallocated mctp_pktbuf pointer (i.e. into a small attacker-advanceable offset above address 0), producing memory corruption or a hard fault. The same handler also performs a write-then-check bounds test, allowing a one-byte heap overflow at data[255] when more than 255 data bytes are sent. Because the I2C target callback is invoked with raw bytes supplied by whatever device is the bus master and the binding performs no authentication, a malicious or malfunctioning controller on the bus can trigger these without any prior protocol state, leading to memory corruption and/or denial of service on the target device. The vulnerable code was introduced when the I2C+GPIO target binding was added and shipped in Zephyr v4.3.0 and v4.4.0. The fix defers allocation to the first data byte with a NULL check, treats a missing length as a zero-sized packet rejected by libmctp, and moves the bounds check before the store.