CVE-2025-71127
HighCVSS 7.1Exploitation Probability (EPSS)
Low risk10th percentile - higher than 10% of all known CVEs
Summary
A vulnerability in the Linux kernel's mac80211 subsystem allows accepting Beacon frames sent to a non-broadcast address. According to IEEE 802.11, Beacon frames must be sent to the broadcast address only, and unicast Beacons can be used in CSA attacks to move stations to a rogue channel. The issue is critical when Beacon protection (BIGTK) is enabled, as the current logic fails to drop unicast frames with the protection bit set, allowing bypass of protection.
Risk Assessment
The organization is at risk of man-in-the-middle attacks or targeted channel migration via crafted Beacon frames, potentially leading to traffic interception or Wi-Fi service disruption for users.
Recommendation
Immediately update the Linux kernel to a version containing the fix that discards Beacon frames sent to a non-broadcast address. Monitor your distribution for the patch and apply it as a priority.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: Discard Beacon frames to non-broadcast address Beacon frames are required to be sent to the broadcast address, see IEEE Std 802.11-2020, 11.1.3.1 ("The Address 1 field of the Beacon .. frame shall be set to the broadcast address"). A unicast Beacon frame might be used as a targeted attack to get one of the associated STAs to do something (e.g., using CSA to move it to another channel). As such, it is better have strict filtering for this on the received side and discard all Beacon frames that are sent to an unexpected address. This is even more important for cases where beacon protection is used. The current implementation in mac80211 is correctly discarding unicast Beacon frames if the Protected Frame bit in the Frame Control field is set to 0. However, if that bit is set to 1, the logic used for checking for configured BIGTK(s) does not actually work. If the driver does not have logic for dropping unicast Beacon frames with Protected Frame bit 1, these frames would be accepted in mac80211 processing as valid Beacon frames even though they are not protected. This would allow beacon protection to be bypassed. While the logic for checking beacon protection could be extended to cover this corner case, a more generic check for discard all Beacon frames based on A1=unicast address covers this without needing additional changes. Address all these issues by dropping received Beacon frames if they are sent to a non-broadcast address.