CVE-2025-68337
HighCVSS 7.5Exploitation Probability (EPSS)
Low risk38th percentile - higher than 38% of all known CVEs
Summary
In the Linux kernel's ext4/jbd2 filesystem, a vulnerability was found where BUG_ON is triggered in jbd2_journal_get_create_access() when the filesystem is corrupted. Inconsistent data (e.g., unset block bitmap) can cause a block being committed to be reallocated, leading to a kernel crash.
Risk Assessment
An attacker or hardware failure can corrupt the filesystem, and in errors=continue mode, the BUG_ON causes a full kernel panic. This results in service disruption and potential data loss.
Recommendation
Apply the kernel patch that replaces BUG_ON with a safe JBD abort immediately. Updating to a kernel version containing this fix is critical for system stability.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: jbd2: avoid bug_on in jbd2_journal_get_create_access() when file system corrupted There's issue when file system corrupted: ------------[ cut here ]------------ kernel BUG at fs/jbd2/transaction.c:1289! Oops: invalid opcode: 0000 [#1] SMP KASAN PTI CPU: 5 UID: 0 PID: 2031 Comm: mkdir Not tainted 6.18.0-rc1-next RIP: 0010:jbd2_journal_get_create_access+0x3b6/0x4d0 RSP: 0018:ffff888117aafa30 EFLAGS: 00010202 RAX: 0000000000000000 RBX: ffff88811a86b000 RCX: ffffffff89a63534 RDX: 1ffff110200ec602 RSI: 0000000000000004 RDI: ffff888100763010 RBP: ffff888100763000 R08: 0000000000000001 R09: ffff888100763028 R10: 0000000000000003 R11: 0000000000000000 R12: 0000000000000000 R13: ffff88812c432000 R14: ffff88812c608000 R15: ffff888120bfc000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 00007f91d6970c99 CR3: 00000001159c4000 CR4: 00000000000006f0 Call Trace: <TASK> __ext4_journal_get_create_access+0x42/0x170 ext4_getblk+0x319/0x6f0 ext4_bread+0x11/0x100 ext4_append+0x1e6/0x4a0 ext4_init_new_dir+0x145/0x1d0 ext4_mkdir+0x326/0x920 vfs_mkdir+0x45c/0x740 do_mkdirat+0x234/0x2f0 __x64_sys_mkdir+0xd6/0x120 do_syscall_64+0x5f/0xfa0 entry_SYSCALL_64_after_hwframe+0x76/0x7e The above issue occurs with us in errors=continue mode when accompanied by storage failures. There have been many inconsistencies in the file system data. In the case of file system data inconsistency, for example, if the block bitmap of a referenced block is not set, it can lead to the situation where a block being committed is allocated and used again. As a result, the following condition will not be satisfied then trigger BUG_ON. Of course, it is entirely possible to construct a problematic image that can trigger this BUG_ON through specific operations. In fact, I have constructed such an image and easily reproduced this issue. Therefore, J_ASSERT() holds true only under ideal conditions, but it may not necessarily be satisfied in exceptional scenarios. Using J_ASSERT() directly in abnormal situations would cause the system to crash, which is clearly not what we want. So here we directly trigger a JBD abort instead of immediately invoking BUG_ON.

