CVE-2024-14040
HighCVSS 7.8Exploitation Probability (EPSS)
Low risk4th percentile - higher than 4% of all known CVEs
Summary
In the Linux kernel, the next hop weight was increased from 8 bits to 16 bits to support larger ECMP weight ratios in CLOS networks. The change repurposed the reserved field resvd1 in the nexthop_grp structure to store high-order weight bits.
Risk Assessment
Organizations using CLOS networks may face limitations when configuring ECMP weights larger than 255, preventing precise load balancing after link failures. Without the update, bandwidth utilization may be suboptimal.
Recommendation
Update the Linux kernel to a version containing this fix (e.g., 6.8 or later) and ensure configuration tools (e.g., iproute2) are updated to handle 16-bit weights.
Other vulnerabilities in Linux kernel
See all- CVE-2026-80577Unknown
In the Linux kernel's drm/panthor driver, panthor_fw_load_section_entry() skips BO creation for zero-sized firmware sections but adds them to the section list, leading to NULL pointer dereference in later paths. The fix skips adding such sections to the list.
- CVE-2026-80571Unknown
In the Linux kernel powerpc/pseries papr-phy-attest, missing validation of cmd.length could lead to buffer overflow. The fix adds length checks and fixes memory leaks on error paths.
- CVE-2026-80567Unknown
In the Linux kernel Synaptics RMI4 driver (F54), worker errors were not propagated to the V4L2 queue, causing stale or uninitialized data to be delivered to userspace. The fix adds error checking and marks buffers as error state.
- CVE-2026-80566Unknown
In the Linux kernel, the hynitron_cstxxx driver improperly validated touch count and finger IDs. This can lead to corrupted touch state or out-of-bounds buffer access.
- CVE-2026-80564Unknown
In the Linux kernel, the gve driver lacks an implementation of adjfine, leading to a NULL pointer dereference when triggered from userspace, e.g., via testptp.
- CVE-2026-80563Unknown
A use-after-free vulnerability was found in the Linux kernel's gpio-sloppy-logic-analyzer driver. The 'trigger' debugfs file lacked proper protection, allowing a write to freed memory during device unbind. The issue was fixed by using debugfs_create_file() instead of debugfs_create_file_unsafe().
- CVE-2026-80543Unknown
In the Linux kernel, the xcrb_msg_to_type6cprb_msgx() and xcrb_msg_to_type6_ep11cprb_msgx() functions for s390/zcrypt copy a user space message into a kernel buffer based on length, but further processing assumes 4-byte alignment. As a result, up to 3 bytes of uninitialized kernel memory are forwarded to further processing, potentially exposing kernel memory to the crypto card firmware.
- CVE-2026-80542Unknown
In the Linux kernel, the amdgpu driver for AMD Display has a NULL pointer dereference in amdgpu_dm_crtc_set_vblank() when vblank is enabled or queried before a stream is attached to acrtc_state->stream. This can lead to a system crash.
- CVE-2026-80535Unknown
In the Linux kernel XFS filesystem, during directory tree repair, a self-referential directory may be detected. In such a case, the repair code attempts to lock the same inode twice (double iolock/ilock), leading to a deadlock. The fix detects this corner case and handles it appropriately.
- CVE-2026-80533Unknown
In the Linux kernel XFS filesystem, during AGI repair, the function xrep_iunlink_walk_ondisk_bucket may attempt to use the pointer sc->sa.agi_bp, which can be null if the buffer verifier fails. The fix uses ragi->agi_bp instead, which skips verifier checks, to avoid walking off the end of memory.
Original NVD description (English source)
In the Linux kernel, the following vulnerability has been resolved: net: nexthop: Increase weight to u16 In CLOS networks, as link failures occur at various points in the network, ECMP weights of the involved nodes are adjusted to compensate. With high fan-out of the involved nodes, and overall high number of nodes, a (non-)ECMP weight ratio that we would like to configure does not fit into 8 bits. Instead of, say, 255:254, we might like to configure something like 1000:999. For these deployments, the 8-bit weight may not be enough. To that end, in this patch increase the next hop weight from u8 to u16. Increasing the width of an integral type can be tricky, because while the code still compiles, the types may not check out anymore, and numerical errors come up. To prevent this, the conversion was done in two steps. First the type was changed from u8 to a single-member structure, which invalidated all uses of the field. This allowed going through them one by one and audit for type correctness. Then the structure was replaced with a vanilla u16 again. This should ensure that no place was missed. The UAPI for configuring nexthop group members is that an attribute NHA_GROUP carries an array of struct nexthop_grp entries: struct nexthop_grp { __u32 id; /* nexthop id - must exist */ __u8 weight; /* weight of this nexthop */ __u8 resvd1; __u16 resvd2; }; The field resvd1 is currently validated and required to be zero. We can lift this requirement and carry high-order bits of the weight in the reserved field: struct nexthop_grp { __u32 id; /* nexthop id - must exist */ __u8 weight; /* weight of this nexthop */ __u8 weight_high; __u16 resvd2; }; Keeping the fields split this way was chosen in case an existing userspace makes assumptions about the width of the weight field, and to sidestep any endianness issues. The weight field is currently encoded as the weight value minus one, because weight of 0 is invalid. This same trick is impossible for the new weight_high field, because zero must mean actual zero. With this in place: - Old userspace is guaranteed to carry weight_high of 0, therefore configuring 8-bit weights as appropriate. When dumping nexthops with 16-bit weight, it would only show the lower 8 bits. But configuring such nexthops implies existence of userspace aware of the extension in the first place. - New userspace talking to an old kernel will work as long as it only attempts to configure 8-bit weights, where the high-order bits are zero. Old kernel will bounce attempts at configuring >8-bit weights. Renaming reserved fields as they are allocated for some purpose is commonly done in Linux. Whoever touches a reserved field is doing so at their own risk. nexthop_grp::resvd1 in particular is currently used by at least strace, however they carry an own copy of UAPI headers, and the conversion should be trivial. A helper is provided for decoding the weight out of the two fields. Forcing a conversion seems preferable to bending backwards and introducing anonymous unions or whatever.